Skip to content
Damp & mould sensorsTry it free
NLEN
Sensors per room

Every room measured. An alert only when something is really wrong.

A small sensor per room measures temperature and humidity. eyesonrooms compares every room with the room where the thermostat is, with the other rooms and with the weather – and explains every alert.

Request a pilot Try the demo

No cameras or microphonesServers in the EUYour data is yours

Where it goes wrong

What you don't see costs money.

You see mould too lateMoisture from showers, cooking and drying laundry settles on the coldest wall.
Heaters nobody reportsPlug-in heating costs electricity and is a fire risk.
A sensor without signalAn empty battery or an unplugged gateway, and you are blind.
One platform

Part of one system.

Sensors, housing management, fault reporting, the route planner and the commute planner share the same houses, rooms and residents. What a sensor measures shows up at the address; a fault report arrives at the right house; the route goes where attention is needed.

The platform

What's included

A small sensor per room measures temperature and humidity. eyesonrooms compares each room with the living room, the other rooms and the weather outside – and only speaks up when something is really going on. More about sensors →

Mould risk in four levelshumidity at the coldest wall.
Plug-in heatersa room that gets noticeably warmer.
Too cold, heating seems offper house, with the weather.
Sensor without signal or flat batteryso you are never blind.
Your own limitsset per customer; every alert with a readable explanation.
Morning overview at 07:30One e-mail with everything that needs attention. Nothing going on? Then no mail either.
Alerts as tasksYou record what was done. The alert closes itself once the room is back to normal.
Report as PDFPer room or per address, with charts and what was done – for the owner or an inspector.
Map, addresses and roomsCards or table, the same colours everywhere: OK, watch, act.
New sensor? It joins by itselfIt lands at the right house; you only pick the room.
Connect a gateway with your phoneOn site, no laptop: the phone sees the new gateway on the same network.
Read alsoPreventing mould in worker housing →Smart sensors in rented rooms →
How it works

Up and running in three steps.

  1. 1A sensor per roomBattery powered; no camera, no microphone – only temperature and humidity.
  2. 2A gateway per houseIn a socket; connects to the house's Wi-Fi.
  3. 3Morning summary at 07:30One email with what needs attention; nothing wrong, no email.
Questions

Frequently asked questions

What does the sensor measure?

Only temperature and humidity. There is no camera, microphone or motion sensor. We measure rooms, not people.

Does the alert take floors into account?

Yes. Per room you set the floor (ground, upper, attic) and where the thermostat is. Warm air rises: a room higher up gets +1 °C per storey before a heater alert.

What does it cost?

From € 4.99 per room per month; the sensors and the gateway are one-off. Ask for a quote.

Who it is for

Made for those who rent out and manage rooms.

Migrant worker housingEnergy, mould and SNFMore Student housingRooms, mould and fault reportingMore Staffing agenciesHousing, beds and commuteMore Housing and facility managersInspections, meters and faultsMore

Start small: a pilot in a few houses.

After a month you know per room where energy leaks away and where mould threatens.

Request a pilot Try it freeTry the demo