Indoor climate in worker housing: what sensors in every room show
How warm and how humid is it really in the rooms of worker housing? In a pilot we measured every room from late September to mid-November 2026. The air was usually fine. The differences are in the bedrooms, in the evening and at the cold wall.
These are first results from a pilot in a limited number of houses, in autumn. This is not a representative study. All figures are anonymous: they contain no companies, addresses or people.
01What did we measure?
In worker houses in different parts of the Netherlands, the rooms had a sensor that measures temperature and relative humidity about every ten minutes. For this analysis we use hourly averages per room from 26 September to 14 November 2026: thousands of room-hours in total. The outdoor temperature for each address comes from Open-Meteo.
We distinguish between bedrooms, the living room (where the thermostat usually is) and other rooms. We measure the air in the room, not the people in it: no cameras, no microphones, no names.
02Are bedrooms warmer than the living room?
Yes, often. The median temperature in the bedrooms was 21.2 °C, in the living rooms 20.7 °C. The difference is mainly in the peaks: bedrooms were warmer than 23.5 °C in 13% of the hours, living rooms in 2.5% of the hours.
Share of all measured hours per type of room. eyesonrooms pilot, 26 September – 14 November 2026.
The thermostat is usually in the living room. If a bedroom is clearly warmer than the room with the thermostat, that heat often comes from something else: a plug-in heater, a radiator turned fully open, the sun or heat from the floor below. A high temperature alone proves nothing, but it is a reason to take a look. What such a heater costs is explained in What does a plug-in heater cost in a rented room?
The differences between houses were large. In one house a bedroom was almost never warmer than 23.5 °C, in another in about one in five hours. In more than half of the houses that share was above 5%.
03When are the rooms warmest?
In the evening. Between 18:00 and 23:00 a bedroom was warmer than 23.5 °C in 16% of the hours, at night in 11%. That fits the moment residents come home from their shift.
Share of bedroom hours in that period. eyesonrooms pilot, autumn 2026.
We see the same pattern in the alerts. The system raises an alert when it suspects extra heating, for example when a room warms up quickly and is clearly warmer than the rest of the house. Two in five of those alerts started between 18:00 and 23:00, and every pilot house had at least one. Where such an alert has been checked on site so far, there really was a plug-in heater. Those checks are still few, so an alert remains a reason to check, not proof.
04How big are the differences within one house?
Bigger than many housing managers think. At the same hour, we compared the warmest and the coldest room in the same house. The median difference was 2.3 °C. In a third of the hours it was 3 °C or more, and in about one in seven hours even 5 °C or more.
In 40% of the rooms it was, in total, at least three hours 3 °C or more warmer than the middle of the house (the median of all rooms at that hour). If you only look at the thermostat in the living room, you do not see that. The other way round, bedrooms were colder than 17 °C in about 5% of the hours; in the living rooms that did not happen. A room that is too cold is also a risk, because cold walls get damp faster.
05Is the air too humid, or the wall?
Usually the wall. The median relative humidity was 54% in the bedrooms and 48% in the living rooms: both within the normal 40 to 60%. But mould does not grow in the air. What matters is the humidity at the surface, at the coldest spot of the wall.
We calculated that surface humidity from the indoor temperature, the indoor humidity and the outdoor temperature, using the method of EN ISO 13788 with an assumed temperature factor of 0.70. In the bedrooms the calculated value was 80% or higher in 14.5% of the hours. At night that happened twice as often as during the day: 22% against 11%. In the living rooms it hardly happened at all.
Striking: the colder it was outside, the more often the wall became too damp, while the air in the room was actually drier.
The humidity of the room air averaged 50% in the coldest group and 61% in the warmest group. eyesonrooms pilot, autumn 2026.
The explanation: when it is cold outside, the inside of the outer wall cools down. Cold air at that wall can hold less moisture, so the humidity at the surface rises, even when the room itself feels fine. That is why winter is mould season, and why a humidity meter in the middle of the room tells you so little.
06Where does real mould risk arise?
A short peak is not mould yet. According to research widely used in building physics, mould only develops when the surface humidity averages around 80% or more over a month; measured over one week, the threshold is higher. If we look at weekly averages, a small group remains: of the rooms with at least a week of data, about one in ten also reached a calculated surface humidity of 80% or more averaged over a whole week. Those rooms were, however, in more than half of the houses for which we had enough data. In the most extreme room, even the humidity of the room air stayed between 75 and 86% for almost a month; there, according to the calculation, the coldest wall was too damp almost all the time.
Such a situation does not resolve itself quickly either. A mould-risk alert stayed open for a median of just over eight days, until the readings were back to normal. An alert for extra heating lasted a median of about ten hours. So mould risk is not an incident, but a condition that lasts for days, usually in a few recurring rooms.
07What does this mean for housing managers?
- Measure every room, not just the living room. The thermostat does not see the warmest and the dampest rooms.
- Watch the evening. To find extra heating, look at bedrooms that warm up quickly between 18:00 and 23:00.
- Ventilate bedrooms at night. An open trickle vent or a window on the latch does more than an hour of airing in the daytime. More in Ventilating rooms in winter.
- No laundry drying in the bedroom, and no furniture against the outer wall. That keeps the coldest spot drier.
- Do not let rooms get too cold. A room below 17 °C gets damp at the wall faster.
- Tackle the rooms that keep coming back. The risk is usually in the same few rooms. Record what you did; that also helps in an SNF inspection. See Preventing mould in worker housing.
08What are the limitations of these figures?
- This is a pilot in a limited number of houses over a short period in autumn, with an average outdoor temperature of about 8 °C. In a hard winter the risks are likely to be higher.
- The surface humidity is calculated, not measured. We assumed a temperature factor of 0.70. For new builds the Dutch building regulations (Bbl) require at least 0.65; for existing homes there is no requirement. At thermal bridges the real value can be lower, and then the risk is higher than calculated here.
- An alert for extra heating is a signal, not proof. A warm room can also be caused by the sun or a radiator.
- The houses were not chosen at random and say nothing about all worker housing in the Netherlands.
We will add to these figures as more houses and a full winter come in.
Contracts and beds per resident in one place
With eyesonrooms you track per bed who lives there, which contract applies and when the last inspection was. So the evidence is ready when someone asks.
Request a pilotSee also the pricing.
09Frequently asked questions
What humidity is normal in a bedroom?
Between 40 and 60%. In this pilot the median humidity in bedrooms was 54%. More important is the humidity at the coldest wall: it can go above 80% while the air in the room is normal.
Why is a bedroom warmer than the living room with the thermostat?
Often because of an extra heat source, such as a plug-in heater or a radiator turned fully open. Sun or heat from a lower floor can also play a part. In this pilot, bedrooms were warmer than 23.5 °C in 13% of the hours, living rooms in 2.5%.
At what humidity does mould grow?
Mould grows at the surface, not in the air. A commonly used threshold is a surface humidity averaging 80% or more over a month. Short peaks are not enough; walls that stay damp are.
Are these figures representative of all worker housing?
No. This is a pilot in a limited number of houses in autumn 2026. The figures show patterns worth checking in your own houses, but it is not a national study.
10Sources
- RIVM: Dutch public health guideline on damp and mould in homes (2012, Dutch)
- ISO 13788:2012: internal surface temperature to avoid critical surface humidity
- Tsongas and Riordan: Minimum Conditions for Visible Mold Growth, ASHRAE Journal (2016)
- Dutch Buildings Decree (Bbl): temperature factor for new builds (Dutch)
- WHO: Guidelines for indoor air quality: dampness and mould (2009)
- Open-Meteo: weather data (outdoor temperature per address)
11Read also
Start small: a pilot in a few homes.
After a month you know how many rooms really use a heater and where damp is a risk. Measured, per room, with the address.